Low Voltage Electric Radiant Heat

ZMesh is a technologically advanced product developed by Heatizon Systems that provides floor warming , snow melting, roof deicing, and total space heating needs.

ZMesh is a 9 or 12 inch wide bronze mesh heating element used for in -floor radiant space heating, radiant floor warming, and roof deicing. Zmesh can be installed under non -metallic shingles and single ply membrane and under most floor coverings including carpet, hardwood, laminates, tile, slate, marble, and linoleum/vinyl. ZMesh's durability is also perfect for your remodeling/retrofit applications.


ZMesh 12" is and excellent product for heating the entire home or for simply heating your floors. ZMesh 12" - wide, bronze mesh is similar to screen door material and comes in 50 to 350 foot rolls (in 50 ft. increments). ZMesh is a premier product because of its extremely low profile and ability to heat evenly. No other heating products can match its characteristic. Because ZMesh is so thin, it will not affect floor buildup, weight loads or flooring choices. ZMesh can be secured to wood sub floors with staples or nails and to concrete with glue or tape. ZMesh can even be installed underneath the cement board when used to heat tile. No additional mortar or thin set is needed to cover the heating system because it is sandwiched in between the sub floor and cement board. Because Heatizon Systems's ZMesh products operate under 32 volts, it is possible to safely put your hand directly on the ZMesh during operation.

ZMesh 9" is used for melting ice and snow under non -conductive shingles or surface asphalt, shake or slate shingle roofs and is ideal for new construction or remodeling. It is only 1/16" thick. Our ZMesh 9" wide element is used for radiant roof deicing and can be nailed or stapled through, making its installation easier than other systems. Costly and disruptive roof ice buildups are eliminated with the use of this unique and low profile roof heating element. The ZMesh is installed underneath the shingles, so its appearance does not compromise the aesthetics of any structure nor is it exposed to weathering or corrosion. The 9" ZMesh is spaced at 2" and rolled out over the area to be heated. Depending on the roofing project, anywhere from 4 to 12 runs of ZMesh may be needed from the roof's edge up. ZMesh can be installed on the entire roof, it is desired to eliminate snow or ice buildup. A great advantage of our roof deicing system is its versatility. You can roll out the ZMesh into any pattern to heat any desired area. ZMesh 9" is the only under roof heating product that is ETL listed.

The ZMesh 9" or 12" is listed to U.L. Standards and the product carries the ETL label. ZMesh has an industry leading 25 year warranty, and is long lasting with its "Warming America's Cold Spots Since 1979" track record.

Featured Product

PureLink - HCE III TX/RX: 4K HDR over HDBaseT Extension System w/ Control and Bi-Directional PoE

PureLink - HCE III TX/RX: 4K HDR over HDBaseT Extension System w/ Control and Bi-Directional PoE

The HCE III Tx/Rx HDBaseT™ extension system offers full HDMI 2.0 compliance supporting HDR (High Dynamic Range) and 4K@60Hz with 4:4:4 chroma sampling. Featuring PureLink's proprietary Pr©cis codec, a light compression technology, the HCE III can transport Ultra HD/4K, multi-channel audio, and High Dynamic Range (10 bits support) content over a single CATx cable. The HCE III provides HDMI extension up to 130 feet (40 meters) at Ultra HD/4K and up to 230 ft. (70 meters) at 1080p over category cable with embedded multi-channel audio, CEC pass-through, bi-directional RS-232 and IR control, and PoE - all with zero loss and zero noise. The HCE III Tx/Rx also supports Dolby TrueHD, Dolby Digital Plus and DTS-HD Master Audio plus LCPM (up to 192 kHz). Additionally, the low profile "slim box" enclosure design make the HCE III ideal for limited space installation environments, such as behind flat panel displays and video walls.