The switch does NOT require a neutral wire. The majority of the rest of European countries (German, France etc) all seem to have their lighting circuits wired differently to the UK (they DO need a neutral wire) and so we couldn't use their switches. The switch will control (and dim) incandescent lights from 60W to 300W.
Powerline Control Systems' SceneMaster system allows multiple lights to be set to various dim levels creating single room or whole house lighting scenes with one command. With 4 switches you can implement a complete single room four light system. No central controller is necessary, only one transmitter and the appropriate number of PCS receivers.
The fact that the LM15A remembers the code even after the power is removed means that you can set up the code in any convenient indoor lamp and then move the module to its final location, which might be in an outside light fixture for example. This means you don't have to install it outside and then run in and out of the house while setting it up.
All in all, this is the nicest X-10 switch that I have seen or used so far (haven't tested PCS or Smartlinc yet though). The switch retails for about $75. I'm almost ready to swap out all of those old pushbuttons and this may be the switch that does it for me.
"In the most common application, the board takes input from a driveway sensor and turns on lighting when a car approaches the house. This is where the LC-6-X10's photocell and built in timer are very useful features"
"Myth: X-10 can't transmit analog data. / Reality: X-10 currently has systems installed (which X-10 developed for Honeywell) employing PLC transmission of both temperature and light levels transmitted using X-10 protocols after A to D conversion."
Records 61 to 73 of 73
C1M1 offers a truly significant reduction in transmission time in comparison to other communicators that rely on dial capture or data bus decoding. This can result in quicker response time to emergency situations which could save lives and assets. By providing both IP and cellular pathways, C1M1 provides the reliability installers are looking for in an alarm communicator. C1M1 eliminates port forwarding and extra fees for remote access. Installers can remotely upload/download programming changes to M1 controls over IP or cellular using ElkRP2. Consumers can control the M1 remotely via the free ElkLink mobile app and web portal, as well as eKeypad and M1 Touch Pro apps. Other IP-based software and interface partners can connect to the M1 control over the local network through C1M1. C1M1 also provides email/text notifications for arm, disarm, and alarm events. ELK-C1M14GSM supports GSM (AT&T/T-Mobile) networks and ELK-C1M1CDMA supports CDMA (Verizon) networks.