Heatit Z-Wave Thermostat - The First Z-Wave Thermostat For Electric Floor Heating

Thermo-Floor AS will at the ISE 2015 in Amsterdam launch the first electronic thermostat incorporating Z-Wave technology for regulating electric floor heating systems.

Heatit Z-Wave is an electronic thermostat for flush mounting in a standard wall box. The thermostat has a built-in Z-Wave chip that can be connected with Home Automation systems like Fibaro, Sensio, Vera, Zipato and others.


Heatit-Z-Wave_studio_hvitThe Heatit Z-Wave thermostat is equipped with a single-pole switch. The thermostat can handle loads up to 16A/3600W at 230V. If the load is greater than this, the thermostat needs to be connected to a contactor. It can be used with two external temperature sensors.

The display will show the ambient temperature, either in the room or in the floor.

The thermostat is equipped with sensitive cap sense buttons. By lightly pressing the buttons, the display will show the set value.

Available in both black or white color.

Functions

* Room sensor
* Floor sensor
* Temperature limiter
* Power regulator
* Z-Wave chip 500 series
* Weekly program via gateway
* Setback mode via gateway or pilot wire
* 7-segment LCD-screen
* Can be used in connection with different NTC-sensors
* Lock mode/child lock
* Backlight
* Calibration
* 8 scenarios

For more information, visit www.heatit.com

Featured Product

Platinum Tools - ezEX-RJ45 Termination & Test Kit

Platinum Tools - ezEX-RJ45 Termination & Test Kit

The new EXOtm Crimp Frame and ezEX-RJ45® Connectors provide the solution for terminating larger diameter Cat6/6A twisted-pair cables. Made in USA. • Conductor sizes up to .048", • Die sets for EZ-RJ45 & ezEX-RJ45 connectors • Feed-through EZ-RJ45 design verifies EIA568A/B wiring • One-step to crimp and flush cut/trim EZ-RJ45 conductor