Marmitek introduces the GigaVideo580™! The video transmitter which is insensitive for WiFi, Bluetooth or microwave

A video transmitter which sends the images of your hard disk recorder, satellite receiver or digital TV decoder to a second TV in your house. With this you can enjoy your centrally recorded or saved images and sounds everywhere in your house!

No need to pull cables

The GigaVideo580 sends the audio and video signal wirelessly through walls and ceilings. So pulling cables and drilling holes is no longer necessary.

5.8GHz Frequency band
Most video transmitters operate on the 2.4GHz frequency band. The GigaVideo580 is an exception to this. It sends the audio and video signal via the 5.8GHz frequency band. The difference between video transmitters with a 2.4GHz signal and a 5.8GHz signal is that this last one is insensitive for elements in the house at the 2.4GHz frequency band like a wireless (WiFi) network, Bluetooth devices, microwave ovens and wireless telephones.

Operating the connected A/V device
Operating the connected A/V device is possible from the location of both TVs. So you don't need to go to another room to pause the movie or change the channel. You can just use the original remote control of the connected A/V device.

Price
This high -quality video transmitter has a suggested consumer retail price of 79,95 GBP including VAT.

Featured Product

GreenPeak’s GP565 – ZigBee for smart Remote Controls

GreenPeak's GP565 - ZigBee for smart Remote Controls

The GP565 Smart Home RF chip for remote controls supports voice control, motion sensing and the new ZRC 2.0 protocol. The GP565 is optimized for advanced & low cost ZigBee RF4CE remote controls. • 120k or 248k Flash (8k or 16k RAM) memory • 40-pin footprint to support a keyboard scanner interface or other IO interfaces required for remote controls. • Reduced current consumption and improved receiver sensitivity and output power • Patented Antenna Diversity technology enables superior range and WiFi/Bluetooth interference rejection