Atlona Releases DVI Over CAT5 Extenders, with a Twist

Atlona's New DVI baluns will allow remote viewing without sacrificing local monitors.

San Jose, CA - May 26, 2008 - Atlona Technologies has become well know as a leading manufacturer of video extenders. The recently brought a solid HDMI single CAT5 extender to the market, and have now set there sights on DVI. "The new AT -DVI150SR is much more than you average extender" says Atlona's Product manager, Michael Khain. "It will not only extend DVI up to 50 meters at hi resolutions, but has a built in booster and equalizer." The booster will allow users to connect an additional 25 meters of DVI cable to the receiver end of the AT -DVI150SR. The device also features a "loop out" for connecting a local monitor. This extender uses two CAT5 cables, one for video and stereo analog audio information, and another for DATA such as EDID and DDC information.

Compliance and more!
The AT -DVI150SR is fully HDCP compliant and can easily connect to a Blu -Ray player or other High Definition Copyright Protection compliant device. It also supports DDC, EDID and hot plug detection. This extender is designed for simple set up and, with its full range of compatibility, will work with pretty much any DVI application.
The AT -DVI150SR is expected to start shipping by late June, and will make its Debut at the 2008 InfoComm Tradeshow.

For more information, press only:
Christopher Bundy, (408) 954 -8782 Ext 113,

For more information on Atlona Products:

Featured Product

MIDLITE®'s SPEEDPORT Universal Cable Pass Thru, Fastening & Anchor System

MIDLITE®'s SPEEDPORT Universal Cable Pass Thru, Fastening & Anchor System

Use for any Low Voltage Cabling, A/V, Telecom, Data, Networking Ideal for : Sound Bars & Wall Speakers • Home Theater Cabling • A/V Furniture The SPEEDPORT™ is incredibly versatile and is ideal for wall mounted box speakers, sound bars and wireless access devices mounted in ceilings. It can accommodate almost any device needed to be hung on a wall or ceiling with cable pass thru and mounting. The ultra low profile design features a rubber grommet insert for bulk cable pass thru. Two mounting screws are hidden behind the grommet and offer a clean, unobtrusive presentation. Installation is quick & simple using a hole saw and attaches to acoustical ceiling tiles and/or gypsum board. Reducing labor and a whole lot of mess from hand cutting large rectangular holes - Low voltage brackets are no longer needed. Just cut your hole in the desired location, insert SPEEDPORT™ and tighten adjustable mounting arms to fasten securely.