Handheld Programmer for PIC and AVR now with USB Interface

Kanda have added a USB interface for loading their handheld programmers. These programmers can power a target circuit and use a single button press to make programming as easy as possible, without needing a computer or even a power supply.

Kanda have added a USB interface to simplify loading their Handheld programmers. These programmers are quite unlike complex handheld programmers with loads of buttons and countless menu choices that baffle even the expert engineer.


The key feature is that they have one button and one LED. This means that they are really easy to use, as they are just plugged into a target circuit and the button is pressed. A green light means successful programming and a red light means try again.

The decision about what device to program, what files to use and different Fuse and Security Bit settings is made when the programmer is loaded from the PC, using the simple software supplied and the new USB interface. Once the programmer is loaded, no thought is needed to program a target circuit.

The Handheld Programmer can power a target circuit at a suitable voltage, either using the built -in PP3 battery or an external 9V supply. So, programming a device or updating the firmware in a target microcontroller can be done without a computer or a power supply, and just by pressing one button.

The settings are saved by the programmer even if the battery goes flat, so as many targets can be programmed as required. Once this is accomplished, the programmer is just connected to the PC again and different settings are loaded for the next job, and so on as many times as needed.

This programmer has been used on production lines with one programmer for every job, each with a suitable label to eliminate any possibility of error, by unskilled staff without constant supervision. It has also been used to update equipment in the store room or at distributor's premises when the firmware needs replacing, again without needing an engineer with a laptop. The handheld programmers provide an alternative to PCs on the production line or visits by expensive engineers and mean that inexperienced staff or customers can do updates without risk or mistakes.

About Kanda:
Kanda manufacture and supply a wide range of embedded system tools. We are specialists in In System Programming, low cost emulators and training systems for a wide range of microcontrollers, PLDs and memory devices, including PIC, AVR, ST7 and COP8. We also supply interfaces for USB, CAN Bus and serial to Ethernet conversion.

Issued By Adrian Kanda.com 15th May 2008
Tel: +44 (0)1974 261 273
Email: sales@kanda.com
Web: http://www.kanda.com

Featured Product

PureLink - HCE III TX/RX: 4K HDR over HDBaseT Extension System w/ Control and Bi-Directional PoE

PureLink - HCE III TX/RX: 4K HDR over HDBaseT Extension System w/ Control and Bi-Directional PoE

The HCE III Tx/Rx HDBaseT™ extension system offers full HDMI 2.0 compliance supporting HDR (High Dynamic Range) and 4K@60Hz with 4:4:4 chroma sampling. Featuring PureLink's proprietary Prcis codec, a light compression technology, the HCE III can transport Ultra HD/4K, multi-channel audio, and High Dynamic Range (10 bits support) content over a single CATx cable. The HCE III provides HDMI extension up to 130 feet (40 meters) at Ultra HD/4K and up to 230 ft. (70 meters) at 1080p over category cable with embedded multi-channel audio, CEC pass-through, bi-directional RS-232 and IR control, and PoE - all with zero loss and zero noise. The HCE III Tx/Rx also supports Dolby TrueHD, Dolby Digital Plus and DTS-HD Master Audio plus LCPM (up to 192 kHz). Additionally, the low profile "slim box" enclosure design make the HCE III ideal for limited space installation environments, such as behind flat panel displays and video walls.