AudioSource® Showcases New In -Wall LCR Speaker at 2007 CEDIA EXPO

At Only $169.99 MSRP and Designed to Fit Between Two Wall Studs, the AS515 is Ideal for Either Center Channel or Three Piece Front Channel Home Theater Audio Applications

DENVER, Sept. 6, 2007 - AudioSource®, a division of Rodin, announced that it will showcase its new AS515 LCR in -wall home theater speaker at the 2007 CEDIA Expo, held from Sept. 6 -9 at the Colorado Convention Center, booth #516. At an affordable $169.99 MSRP, the AS515 is ideal for either center channel or three piece front channel home theater audio applications.


"Price point, ease of installation, convenience of 'off the floor' LCR speakers, and rich sound reproduction makes the AudioSource AS515 LCR speakers a must have," explained Stewart Millager, AudioSource director of engineering. "The dual 5.25 -inch configuration allows for custom mounting between two 16 -inch separated wall studs. The carbon filled polypropylene drivers and one inch swivel mounted silk soft dome tweeter provide reliable, rich sound reproduction with a platform that allows the end user to direct audio to the sweet spot in any home theater room."

Additional AudioSource AS515 LCR in -wall home theater speaker specs include:
• Sized to fit between two studs
• Woofer: dual 5.25 -inch carbon filled poly cone w/butyl rubber surround
• Tweeter: 1 -inch swivel mounted silk soft dome
• Frequency Response: 60 Hz to 20 KHz
• Impedance: 8 Ohm
• Sensitivity: 85dB@2.83V
• Power Handling: 25 to 150 Watts continuous
• Outer Dimension: 15.35 inches x 8.30 inches (39cm x 21cm)


"Additionally, the AS515 is an exact match to AudioSource's current audiophile series in -wall and in -ceiling speakers to insure the proper timbre matching," added Millager. "The same speaker cones, surrounds, voice coils, and silk soft dome tweeters are used throughout. This allows maximum flexibility when choosing the right set of speakers for either a complete home theater system including both the front staging and surround speakers or for a whole house audio system set up."

Due to continual product improvement, all specifications subject to change without notice.

###

Featured Product

REPLACEMENT INTERCOM SYSTEM WITH BUILT-IN MP3 DISTRIBUTION

REPLACEMENT INTERCOM SYSTEM WITH BUILT-IN MP3 DISTRIBUTION

RETRO-M is designed to replace existing Home Intercom Systems and operate on existing 3 and 4 wire systems. BLUETOOTH you music by adding the BT-RECEIVER. No need to remove existing master wall housing, trim plates available to cover those large holes. The RETRO-M intercom unit has a built-in AM/FM radio. Plug in mp3 players such as iPod, iPhone, Zune or any other hand held player into the master and share your music with the entire family. Choose between two music sources; listen to the radio in one room and the mp3 in another room.