Radio-controlled systems allow wireless remote control of existing residential lighting. The communication link between the PLC and the radio-controlled system is an RS232 interface unit. The connection is via a standard DB-9 serial cable between the PLC and the RS232 interface unit. Both devices should be mounted close together as per the RS232 minimum power requirements.

Programmable Logic Controller - Wireless Lighting Control

Eugene Kowch | P.I.D. Consultants Inc.

October 2008

Programmable Logic Controller - Wireless Lighting Control

Author: Eugene Kowch, P.I.D. Consultants Inc.

Radio-controlled systems allow wireless remote control of existing residential lighting. The communication link between the PLC and the radio-controlled system is an RS232 interface unit. The connection is via a standard DB-9 serial cable between the PLC and the RS232 interface unit. Both devices should be mounted close together as per the RS232 minimum power requirements.

Radio-controlled systems eliminate the need for communication wiring between wall-mounted switches and the Programmable Logic Controller (PLC). Radio transmitters communicate with the PLC via radio frequency (RF) signals. PLCs control other residential electrical devices that are not part of the radio-controlled system. Linking the PLC and the radio-controlled system together provides for an overall control system that can employ multiple transmitters for multiple location control.

1

The communication link between the PLC and the radio-controlled system is an RS232 interface unit. The connection is via a standard DB-9 serial cable between the PLC and the RS232 interface unit. Both devices should be mounted close together as per the RS232 minimum power requirements.

The PLC is connected to residential electrical devices that are not part of the radio-controlled system (outdoor lights, motor operated drapes, fireplaces, etc). Because the two systems are linked via the RS232 interface, a button push on a radio-controlled keypad can now operate motor operated drapes or turn a fireplace on/off. Also, the PLC can turn on/off lights on the radio-controlled system based on its timeclock or security functions.

Radio frequencies from many other sources can interfere with proper operation of this type of control system however. These radio systems are also relatively expensive, but they are useful where the controlled electrical devices are difficult to access. They are also suited to retrofit applications where control wiring would be difficult or expensive to install.


2


Comments (0)

This post does not have any comments. Be the first to leave a comment below.


Post A Comment

You must be logged in before you can post a comment. Login now.

Featured Product

PureLink - HCE III TX/RX: 4K HDR over HDBaseT Extension System w/ Control and Bi-Directional PoE

PureLink - HCE III TX/RX: 4K HDR over HDBaseT Extension System w/ Control and Bi-Directional PoE

The HCE III Tx/Rx HDBaseT™ extension system offers full HDMI 2.0 compliance supporting HDR (High Dynamic Range) and 4K@60Hz with 4:4:4 chroma sampling. Featuring PureLink's proprietary Pr©cis codec, a light compression technology, the HCE III can transport Ultra HD/4K, multi-channel audio, and High Dynamic Range (10 bits support) content over a single CATx cable. The HCE III provides HDMI extension up to 130 feet (40 meters) at Ultra HD/4K and up to 230 ft. (70 meters) at 1080p over category cable with embedded multi-channel audio, CEC pass-through, bi-directional RS-232 and IR control, and PoE - all with zero loss and zero noise. The HCE III Tx/Rx also supports Dolby TrueHD, Dolby Digital Plus and DTS-HD Master Audio plus LCPM (up to 192 kHz). Additionally, the low profile "slim box" enclosure design make the HCE III ideal for limited space installation environments, such as behind flat panel displays and video walls.