With motorized drapery connected to the PLC, not only will the homeowner control the blinds from keypads on the wall, but can have them open or close depending on amount of sunlight coming into the room automatically.

Programmable Logic Control - Drapery

Eugene Kowch | P.I.D. Consultants Inc.

Programmable Logic Controller
 ---- Drapery ----
By Eugene Kowch, P.I.D. Consultants Inc.

With motorized drapery connected to the PLC, not only will the homeowner control the blinds from keypads on the wall, but can have them open or close depending on amount of sunlight coming into the room automatically.


The programmable logic controller (PLC) has been shown to be a good lighting control unit. One touch of a button and the lights in a room come on "just so" to suit a particular activity or mood. This is great during the nighttime when the daylight is absent. How do you control the light in a room during the daytime? With drapery, of course!

Drapery is a given in any room with windows. Most window treatments are manually operated with pull strings. Nowadays drapes and blinds can be motorized with switches on the wall to operate them open or closed. Depending on the size of room and number of blinds, there could be quite a few switches on the wall. This is where the PLC helps to minimize the wall clutter.

All motorized drapery comes with their own controllers that interface with other control systems. The drapery controllers usually come with dry contact closure inputs that work perfectly with the PLC. All motorized drapery controllers have an open, close and stop input. Some have raise/lower and preset inputs. The PLC was dry contact outputs that wire to these drapery controllers easily. The drapery controllers and PLC should be in the same location, like a storage room or closet, to minimize wire lengths. Once the drapery controllers are wired to the PLC, the shades adjust as lights dim or brighten to generate the light levels for any mood or activity. Keypads, which are connected to the PLC, are aesthetically consistent and allow for lighting and drapery control from one location.

With motorized drapery connected to the PLC, not only will the homeowner control the blinds from keypads on the wall, but can have them open or close depending on amount of sunlight coming into the room automatically. The drapes can open with the morning clock alarm in the bedroom or simply with the sunrise time from an astronomical timeclock.

Here are a few drapery control solutions:

http://www.somfysystems.com/
http://www.lutron.com/shadingsolutions/
http://www.silentgliss.ca/


Comments (0)

This post does not have any comments. Be the first to leave a comment below.


Post A Comment

You must be logged in before you can post a comment. Login now.

Featured Product

PureLink - HCE III TX/RX: 4K HDR over HDBaseT Extension System w/ Control and Bi-Directional PoE

PureLink - HCE III TX/RX: 4K HDR over HDBaseT Extension System w/ Control and Bi-Directional PoE

The HCE III Tx/Rx HDBaseTâ„¢ extension system offers full HDMI 2.0 compliance supporting HDR (High Dynamic Range) and 4K@60Hz with 4:4:4 chroma sampling. Featuring PureLink's proprietary Pr©cis codec, a light compression technology, the HCE III can transport Ultra HD/4K, multi-channel audio, and High Dynamic Range (10 bits support) content over a single CATx cable. The HCE III provides HDMI extension up to 130 feet (40 meters) at Ultra HD/4K and up to 230 ft. (70 meters) at 1080p over category cable with embedded multi-channel audio, CEC pass-through, bi-directional RS-232 and IR control, and PoE - all with zero loss and zero noise. The HCE III Tx/Rx also supports Dolby TrueHD, Dolby Digital Plus and DTS-HD Master Audio plus LCPM (up to 192 kHz). Additionally, the low profile "slim box" enclosure design make the HCE III ideal for limited space installation environments, such as behind flat panel displays and video walls.